Planning Capacity Requirements for Spiral Pipe Production Time with Capacity Requirement Planning (CRP) Method at A Pipe Production Company in Sidoarjo
DOI:
https://doi.org/10.11594/nstp.2022.2734Keywords:
CRP, Capacity Requirement Planning, Spiral PipeAbstract
Company resources that are less effective and efficient cause problems in the production planning of PT. X, a company engaged in manufacturing spiral pipes, often experiences time delays in the spiral pipe production process due to a large number of requests, so the fulfillment of consumer demands is hampered. To overcome these problems, this research was conducted using the Capacity Requirement Planning (CRP) method so that companies can plan and implement arrival rates to adjust orders according to the available time capacity and identify work center areas where the production process is faster. The data processing that has been carried out shows different results between the company's methods, namely getting a total lack of time capacity of 549.77 hours, while the CRP method gets a total lack of time capacity of 288.2 hours so the CRP method is considered better because of the total shortage of time capacity. produced is smaller than the company's previous method.
Downloads
Published
Issue
Section
License
Copyright (c) 2022 Rusindiyanto, Rizqi Novita Sari
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with this proceedings agree to the following terms:
Authors retain copyright and grant the Nusantara Science and Technology Proceedings right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this proceeding.
Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the proceedings published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this proceeding.
Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See the Effect of Open Access).
